Content
Summary
After a radiofrequency pulse, the transverse magnetization precesses and decays, inducing a signal called the free induction decay (FID) in the receiver coil. The Fourier transform converts this time-domain signal into a frequency-domain spectrum, in which each precessing frequency appears as a peak whose width reflects its decay rate.
Intuition
The FID is a sum of decaying oscillations, one for each chemical environment. In the time domain they overlap and interfere, so the signal looks like a messy wiggle. The Fourier transform acts like a bank of tuning forks: for each test frequency it asks how strongly the signal oscillates at that frequency. Frequencies present in the signal give large responses (peaks), and others cancel to near zero. A fast-decaying signal is short in time and therefore broad in frequency; a slowly decaying one gives a narrow, sharp peak. This is why T2* (decay time) sets the linewidth.
Key equations
Complex FID of a single resonance at offset frequency nu0 with decay time T2*.
Fourier transform: spectrum S at frequency nu.
Result for one decaying exponential: a Lorentzian line centred at nu0.
Full width at half maximum of the absorption peak.
Derivation
- Start with the single-resonance FID s(t)=A exp(i2πν0 t) exp(-t/T2*) for t≥0, and zero for t<0.
- Insert into the Fourier integral: S(ν)=A∫0^∞ exp[-(1/T2* + i2π(ν-ν0))t] dt.
- Combine the exponents; the integral of exp(-at) from 0 to infinity is 1/a when Re(a)>0, which holds since 1/T2*>0.
- So S(ν)=A/(1/T2* + i2π(ν-ν0)).
- Multiply top and bottom by the complex conjugate to separate real and imaginary parts: Re S = A(1/T2*)/((1/T2*)²+(2π(ν-ν0))²), the absorption Lorentzian; Im S is the dispersion part.
- The real part falls to half its maximum when 2π|ν-ν0|=1/T2*, giving full width Δν=1/(πT2*).
Worked example
An FID has a single resonance at 100 Hz offset and T2* = 0.10 s. Find the peak position and the full width at half maximum of the spectral line.
- The FID is exp(i2π·100·t) exp(-t/0.10).
- The Fourier transform peaks at ν0 = 100 Hz.
- Use Δν = 1/(π T2*) = 1/(π × 0.10).
- 1/(0.314) ≈ 3.18 Hz.
Answer Peak at 100 Hz with a linewidth of about 3.2 Hz.
Common mistakes
- Thinking the peak height and width are independent: for a fixed amplitude A, a shorter T2* gives a broader and lower peak.
- Confusing the angular frequency ω (rad/s) with ν (Hz), which introduces errors of 2π in the linewidth.
- Forgetting that the real part is absorption and the imaginary part is dispersion, so an unphased spectrum looks distorted.
- Believing the spectrum frequency is the absolute Larmor frequency; it is usually the offset from the receiver reference frequency.
- Ignoring that sampling limits the spectral range: the width is 1/Δt, so too slow sampling causes aliasing.