Content
Summary
COSY is the simplest 2D NMR experiment: a 90° pulse, an evolution delay t1, a second 90° pulse, then acquisition during t2. The second pulse transfers coherence between J-coupled spins, so frequencies evolved in t1 appear at different frequencies in t2, producing off-diagonal cross-peaks that reveal scalar connectivity.
Intuition
Picture two coupled spins A and X. The first pulse tips A magnetization into the transverse plane, where it precesses at its own frequency during and is also modulated by coupling, so the A doublet components drift apart in phase. Without coupling, the second pulse would simply tip some magnetization back to or leave it transverse, and A would be labeled with the A frequency in both dimensions, giving only diagonal peaks. With coupling, the antiphase component of A (the part with the A vector split into two opposite-pointing doublet lines, proportional to ) is converted by the second pulse into antiphase magnetization on X. That X coherence was labeled with A's frequency in but now precesses at X's frequency in . This yields a cross-peak at (, ). The geometry: in-phase A stays on A (diagonal), antiphase A moves to X (cross).
Key equations
Diagonal-peak term: A frequency in both dimensions, in-phase component after pulse 2.
During t1 in-phase magnetization partly becomes antiphase because of J coupling.
The second 90° pulse converts antiphase A coherence into antiphase X coherence: coherence transfer.
Cross-peak term: labeled by A in t1, X in t2, antiphase in both dimensions.
Derivation
- Start at equilibrium with Iz for each spin. A 90° pulse about x gives -Iy (take as Ix-like transverse magnetization for A).
- During t1, chemical shift rotates the vector at Omega_A: Ix -> Ix cos(Omega t1) + Iy sin(Omega t1).
- evolves in-phase into antiphase: .
- Keep the antiphase term modulated by .
- The second 90°x pulse rotates Iy->Iz and Xz->-Xy, so 2 Iy Xz becomes -2 Iz Xy: antiphase coherence now on X.
- During , evolves at and the antiphase becomes observable in-phase signal with .
- Fourier transform in t1 and t2 gives a peak at (Omega_A, Omega_X), which is a cross-peak. The in-phase term remaining on A gives the diagonal peak at (Omega_A, Omega_A).
Worked example
In a COSY of ethyl acetate-like fragment CH3-CH2 (J = 7 Hz, CH3 at 1.2 ppm, CH2 at 4.1 ppm, 400 MHz), where do cross-peaks appear, and what t1 gives maximal antiphase transfer?
- Convert shifts: 1.2 ppm x 400 = 480 Hz; 4.1 ppm x 400 = 1640 Hz.
- Diagonal peaks lie at (480,480) and (1640,1640) Hz.
- Coherence transfer between the coupled CH3 and CH2 gives cross-peaks at (F1,F2) = (480,1640) and (1640,480) Hz, symmetric about the diagonal.
- Antiphase amplitude goes as , maximal when , so .
- In practice t1 is incremented from near zero and T2 decay limits it, so cross-peaks build up across the increments.
Answer Cross-peaks at (1.2, 4.1) and (4.1, 1.2) ppm; transfer is maximal near t1 = 71 ms, though it is sampled over the whole t1 series.
Common mistakes
- Saying the second pulse creates coupling; it only converts existing antiphase coherence, which exists only because of J evolution in t1.
- Expecting cross-peaks between uncoupled spins (cross-peaks appear for resolved J, usually 2-3 bonds).
- Forgetting that cross-peaks are antiphase in both dimensions while diagonal peaks are in-phase (dispersive in a phase-corrected spectrum), so phasing is tricky.
- Treating COSY as showing NOE or through-space proximity; it shows only scalar coupling.
- Ignoring small J combined with broad lines: antiphase components cancel, so cross-peaks vanish.