Content
Summary
Thin Layer Chromatography begins by dissolving analytes in volatile solvents like acetone or dichloromethane to ensure rapid evaporation and discrete spotting. The development process relies on capillary action within a saturated chamber, where the solvent level must remain strictly below the sample origin line to prevent dissolution into the bulk liquid.
Intuition
Think of TLC as a race where the starting line must be perfectly prepared. If you use a solvent that doesn't evaporate quickly, your starting spot will remain wet and diffuse, ruining the separation. The key is to create a tiny, concentrated dot of your sample. When you place the plate in the chamber, the solvent acts like a sponge, pulling itself up the plate. It is crucial that this liquid reservoir sits below your sample dots; if the dots are submerged, the sample washes away into the beaker instead of traveling up the plate to separate.
Key equations
A practical starting ratio for preparing sample concentration.
Derivation
- Select a volatile solvent (e.g., acetone, diethyl ether, dichloromethane) to ensure rapid evaporation.
- Prepare the sample using a ratio of 1 drop of sample to 50-100 drops of solvent.
- Store the sample in a lidded vial to prevent vapor loss and spillage.
- Prepare a separate vial of clean solvent (e.g., acetone or water) for rinsing spotting tools.
- Construct a saturated chamber using a beaker and watch glass.
- Add eluent to the chamber ensuring the liquid level is below the origin line.
- Spot the sample on the plate and place it in the chamber.
- Allow capillary action to move the solvent up the plate.
- Remove the plate before the solvent front reaches the top.
Worked example
A student prepares an NMR sample of a solid compound in deuterated chloroform. They wish to analyze this compound via TLC. Can they use the NMR sample directly? What is the correct chamber setup if they use dichloromethane as the mobile phase?
- Check if the sample is pre-prepared for NMR.
- The source states NMR samples can be utilized directly for TLC without modification.
- Check the chamber setup requirements.
- The eluent (dichloromethane) must be added to the beaker.
- Ensure the liquid level is strictly below the origin line where the sample will be spotted.
- Cover the beaker with a watch glass to create a saturated environment.
Answer Yes, the NMR sample can be used directly. The chamber must have the dichloromethane level below the origin line, covered with a watch glass.
Common mistakes
- Using non-volatile solvents which interfere with visualization and drying.
- Allowing the solvent front to run off the top of the plate, ruining separation.
- Spotting the sample too high, causing it to dissolve directly into the bulk solvent in the chamber.