Content
Summary
Plasmid cloning inserts a DNA fragment of interest into a circular plasmid vector using restriction enzymes and DNA ligase. The recombinant plasmid is then introduced into bacteria, which copy it as they divide. Success depends on compatible ends, correct insert-to-vector ratios, and selection of the right colonies.
Intuition
Think of a plasmid as a small circular ring of DNA and the insert as a puzzle piece. A restriction enzyme cuts the ring and the donor DNA at specific sequences, leaving matching sticky ends that can base-pair like complementary jigsaw edges. These ends only hold loosely through hydrogen bonds, so DNA ligase seals the sugar-phosphate backbone with phosphodiester bonds, using ATP. Once the ring is closed again, it carries the new piece and bacteria copy it every time they divide. Geometry matters: the ends must be complementary, the insert must face the right direction, and the ring must close without leaving nicks.
Key equations
Mass of insert needed for a chosen molar insert:vector ratio, commonly 3:1.
Ligase forms a phosphodiester bond between adjacent 3' hydroxyl and 5' phosphate groups.
Cutting a linear DNA n times gives n+1 pieces; cutting a circular plasmid n times gives n pieces.
Derivation
- Choose an enzyme, such as EcoRI, that recognises GAATTC and cuts between G and A on each strand.
- Because the site is palindromic, the cut leaves a 5' overhang AATT on both ends of each fragment.
- Cut vector and insert DNA with the same enzyme so that their overhangs are complementary.
- Mix them; overhangs anneal by hydrogen bonding, bringing a 3' OH next to a 5' phosphate.
- T4 DNA ligase uses ATP to join these groups, forming a phosphodiester bond on each strand and closing the backbone.
- Convert the desired 3:1 molar ratio to mass using the lengths of insert and vector.
- Transform competent bacteria and plate on antibiotic to select cells that took up plasmid.
Worked example
You have 50 ng of a 3000 bp vector. How many ng of a 1000 bp insert give a 3:1 insert:vector molar ratio?
- Use ng insert = ratio × ng vector × (insert length / vector length).
- Substitute: 3 × 50 × (1000/3000).
- Compute 1000/3000 = 0.3333.
- Then 3 × 50 × 0.3333 = 50.
Answer 50 ng of insert
Common mistakes
- Using a 1:1 mass ratio instead of a molar ratio, which gives too few insert molecules for a short insert.
- Forgetting to dephosphorylate the vector when using a single enzyme, which lets the vector re-ligate to itself and gives many empty colonies.
- Cutting with enzymes that leave incompatible overhangs, or forgetting that a single-enzyme insert can ligate in either orientation.
- Using old ligase buffer in which ATP has degraded, so ligation fails.
- Not heat-inactivating or removing the enzyme, or carrying over salts that inhibit ligation or transformation.