Content
Summary
Fed-batch fermentation adds nutrient feed to a bioreactor during the run without removing broth, so volume rises while substrate is kept low. This avoids overflow metabolism, substrate inhibition and oxygen limitation, and allows high cell density and product yield. The classic strategy is an exponential feed that holds specific growth rate constant.
Intuition
Imagine feeding a fire: dumping all the wood at once creates smoke and waste (acetate, ethanol, heat), but adding wood at the rate the fire can burn keeps it clean and hot. In a fed-batch, the cells are the fire and the substrate is the wood. Because the feed is the limiting factor, the operator, not the cells, sets the growth rate. Substrate stays near zero, the cells consume it as fast as it arrives, and biomass accumulates. Volume grows, so concentrations are diluted, but total biomass and product mass keep rising until the vessel is full or oxygen transfer limits the culture.
Key equations
Volume rises at the feed rate F (no outflow).
Total biomass mass balance; X is biomass concentration.
Substrate balance with feed concentration S_F, yield Y_{X/S}, maintenance m.
Exponential feed profile keeping quasi-steady S and constant specific growth rate.
Derivation
- Since there is no outflow, total volume obeys .
- Biomass mass: . Expanding gives , so with .
- Substrate mass: d(VS)/dt = F·S_F − (μ/Y + m)VX.
- Assume quasi-steady state with S small (d(VS)/dt ≈ 0, S ≪ S_F) and μ = μ_set under substrate limitation.
- Then F·S_F = (μ_set/Y + m)VX, so F = (μ_set/Y + m)VX/S_F.
- Since VX grows as e^{μ_set t}, F(t) = F_0 e^{μ_set t} with F_0 = (μ_set/Y + m)X_0V_0/S_F.
Worked example
A fed-batch starts with V0 = 2 L, X0 = 10 g/L. Target μ = 0.15 h^-1, Y_X/S = 0.5 g/g, m = 0.02 g/g/h, feed S_F = 400 g/L glucose. Find the initial feed rate and the feed rate after 10 h.
- Substrate demand per gram biomass: μ/Y + m = 0.15/0.5 + 0.02 = 0.32 g/g/h.
- Biomass at start: X0V0 = 10 × 2 = 20 g.
- Glucose demand: 0.32 × 20 = 6.4 g/h.
- .
- After 10 h: F = 0.016 × e^{0.15×10} = 0.016 × 4.48 = 0.0717 L/h.
Answer F0 = 0.016 L/h; F(10 h) ≈ 0.072 L/h
Common mistakes
- Treating concentration X as if it rises with the same formula as in a chemostat; volume dilution matters, so track total mass VX.
- Forgetting maintenance m, which makes the feed too low and lets μ fall below target.
- Continuing exponential feed beyond the oxygen transfer or cooling capacity of the reactor.
- Assuming S is zero exactly; it is small but nonzero, set by Monod kinetics.
- Confusing fed-batch with continuous culture: no broth is withdrawn, so no steady state exists in volume.